Product manual

VessRAID 1000s Series Product Manual
230
Figure 7. Battery connector pins
8. Put the battery assembly into place and install the attaching screw.
9. Replace the RAID Controller cover and install the two attaching screws.
See page 227, Figure 3.
10. Reinstall the RAID Controller.
See “Replacing a RAID Controller” on page 225.
This completes the cache battery replacement procedure.
Replacing the Memory Module
The memory module is a single inline memory module (SIMM) installed on the
main board of the RAID Controller. You might replace the memory module as a
capacity upgrade as well as a repair.
To replace the memory module:
1. Shut down the VessRAID and remove the RAID Controller.
See “Replacing a RAID Controller” on page 225.
Cautions
• Only a qualified technician should perform this procedure.
• You must shut down the VessRAID subsystem before you can
perform this procedure.
• Installing the wrong SIMM will cause boot failure.
No pin
Blank