Product manual

Chapter 7: Maintenance
229
4. Lay the RAID Controller on a non-static surface and remove the cover
attaching screws, one on each side, then remove the cover.
See page 227, Figure 3.
5. Remove the battery assembly attaching screw on the outside of the RAID
controller housing.
6. Detach the battery connector and remove the battery assembly.
Figure 6. RAID Controller cache battery
In the above photo, the memory module was removed so you can see the
battery connector. You do not have to remove the memory module to replace
the battery assembly.
7. Attach the connector of the new battery assembly.
Be careful to line-up the connector pins correctly. See Figure 7.
Attaching screw
(on controller
housing)
Battery
assembly
Mounting
post
Connector