User manual

SuperTrak SX6000™ User Manual Chapter 4
- 32 -
(4) Choose “Win2000 Promise SuperTrak SX6000 (tm) Controller” from the list that
appears on screen then press the [Enter] key.
(5) The “Windows 2000 Setup” screen will appear again saying “Setup will load
support for the following mass storage devices:” The list will include ” Win2000
Promise SuperTrak SX6000 (tm) Controller”
NOTE: If you need to specify any additional devices to be installed do so at
this time. Once all devices are specified continue to step 6.
(6) From the “Windows 2000 Setup” screen, press the [Enter] key. Setup will now
load all device files and then continue the Windows 2000 installation.
Promise Array Management Installation
There are several layers of the Promise Array Management (PAM) software installation
that must be installed on the appropriate network servers/workstations. Make sure the
SuperTrak SX6000 device driver is installed before moving on to install the PAM utility
software.
See the Promise Array Management User Manual for complete installation procedures.