User manual

SuperTrak SX6000™ User Manual Chapter 4
- 30 -
(2) When the “Welcome to Setup” window appears, press [Enter].
(3) When the “Setup Method” dialog box appears, press [Enter] to confirm Express
Setup.
(4) Press “S” to add the SuperTrak SX6000 controller.
(5) Select “Other” (requires disk provided by hardware manufacturer).
(6) Specify “a:\”, insert the Promise driver diskette into drive A: and press [Enter].
(7) Select the “WinNT Promise SuperTrak SX6000 (tm) Controller” and click “OK”.
NOTE: for CD installations, you must also specify the driver for your CD-ROM adapter
(i.e. if using an ATAPI CD-ROM, specify the IDE 2.1 controller)
(1) Follow the normal setup installation procedure.
To check if the driver installation was successful, perform the following steps:
(2) After restarting the system, return to “Control Panel”.
(3) From the “Control Panel”, double-click the “SCSI Adapters” icon.
(4) From the “SCSI Adapters” window, choose the “Devices” tab. You should now
see “Promise SuperTrak SX6000 (tm) Controller” listed.