User manual

SuperTrak SX6000™ User Manual Chapter 3
Controller Configuration
By pressing [5] on the “Main Menu” screen displays the “Controller Configuration –
Options” screen (see below).
[ Keys Available ]
Down [Space] Change Option [ESC] Exit [Ctrl-Y] SaveUp
[

][

]
Driver Version:
IxWorks 1.1 FCS Ver : 0201
PROMISE IDE HDM Ver : 47rm
PROMISE RAID ISM Ver : 47rm
Number of Channels : 6
Processor Memory : 32 MB
Halt on Error = Enable
OS Selection = Windows NT
[ System Resources Configuration ]
[ Controller Configuration - Options ]
SuperBuild Array Utility 1.10 (c) 2001 Promise Technology, Inc.
Figure 14 Controller configuration screen
This screen allows you to modify the “Halt On Error” option (enable/disable) by pressing
the [Spacebar]. “Halt On Error” is enabled if you want the system to halt processing
during bootup if the SuperTrak SX6000 BIOS determines that there is an array error.
The OS Selection option should be selected based on the operating system you will be
using. All other information in the System Resources Configuration section is for display
only. The information presented here is as follows:
Driver Version
Shows the driver software version of the IxWorks operating system, the
Promise Hardware Driver Module (HDM), and the Promise Intermediate
Software Module (ISM).
Number of Channels
Shows the number of channels attached to the SuperTrak SX6000 controller
that may be used to connect one drive each for use in RAID arrays.
Processor Memory
Shows the size of the DIMM plugged into the SuperTrak SX6000 controller
card.
- 28 -