User manual

SuperTrak SX6000™ User Manual Chapter 3

View Drive Assignments

By pressing [2] on the “Main Menu” screen, the “View Drive Assignments” screen is

displayed (see below). This screen does not allow modifications to any of the four

fields.

[ Keys Available ]

[ View Drive Assignments ]

Channel:ID Drive Model Capacity (MB) Assignment

CH 1:Mas XXXXX XXXXXXXXXX

CH 2:Mas XXXXX XXXXXXXXXX

CH 3:Mas XXXXX XXXXXXXXXX

CH 4:Mas XXXXX XXXXXXXXXX

CH 5:Mas XXXXX XXXXXXXXXX

CH 6:Mas XXXXX XXXXXXXXXX

XXXXX

Free

Down [ESC] ExitUp

[



][



]

Figure 6 View Drive Assignments screen

Channel: ID

This field shows the SuperTrak SX6000 controller channel ID (1-6) to which a

particular drive is attached.

Drive Model

This field identifies the manufacturer, model, and model number (if

applicable) of each drive installed on the SuperTrak SX6000 card.

Capacity (MB)

This field reflects the capacity in MB (megabytes) of each drive.

Assignment

This field identifies the array to which each drive belongs. Assigned drives

are labeled with their disk array (1, 2, 3, etc...). Unassigned drives are labeled

“free,” and are considered "hot spares" to provide fault tolerance. Unassigned

drives may also be used to create a new array at any time.

- 17 -