User manual

SuperTrak SX6000™ User Manual Chapter 3
- 16 -
Mode
Items in this field correspond to the selections found in the “Optimize Array
for” field in the “Auto Setup Menu” section (see table on page 15).
Spare Drive
Auto setup does not allow configuring a hot spare drive. If you wish to have a
spare drive, you must use the “View/Define Array Menu” (see page 18) and
manually assign the exact number of drives you want included. Any attached
drive not configured in a fault tolerant array will be recognized as a spare
drive and will be automatically added to the array when a failed drive is
detected. An automatic data rebuild will be performed to restore fault
tolerance as quickly as possible. At a later time, the failed drive can be
physically removed and an extra drive added in its place to function as the
new spare drive.
Drive(s) Used In Array
This field displays the number of drives used in the array. This does not
include the spare drive(s).
Array Disk Capacity
This field displays the capacity available in the entire array in MB
(megabytes), not counting spare drives.
When you have completed your selections, press the [Ctrl-Y] keys. SuperBuild will
create an array automatically from the hard drives connected to the SuperTrak SX6000
controller. SuperBuild will then ask to reboot the system.