User manual

SuperTrak SX6000™ User Manual Chapter 3
Setting the Halt On Error option
(1) In the “Main Menu” press [5] to display the “Controller Configuration” screen.
(2) In the “Controller Configuration – Options” screen, use the [Spacebar] to toggle
the “Enable/Disable” option of the “Halt On Error” feature.
(3) Press the [Ctrl-Y] keys to save the changes.
OS Selection
(1) In the “Main Menu” press [5] to display the “Controller Configuration” screen.
(2) In the “Controller Configuration – Options” screen, use the [Spacebar] to toggle
through the OS Selection options to
(3) NT – Choose this if you are using Windows NT 4.0 or Window 2000
(4) Linux – Choose this if you are using Linux
(5) Other – Choose this if you are using an OS other than Windows or Linux
(6) Press the [Ctrl-Y] keys to save the changes.
SuperTrak BIOS Reference
When the SuperTrak SX6000 BIOS loads during system boot time, it displays pertinent
information about the RAID arrays that it finds, then displays “Press <Ctrl-F> to enter
Array BIOS Configuration Utility” (see below).
SuperTrak SX6000 (tm) BIOS Version 1.10.0 (Build 7)
(c) 2001 Promise Technology, Inc. All rights reserved.
ID MODE SIZE TRACK-MAPPING STATUS
1108/255/631 1x2 Mirror 8629M Functional
Press <Ctrl-F> to enter Array BIOS Configuration Utility...
Figure 3 SuperTrak SX6000 BIOS Startup
The information displayed in the form of a small table contains the following properties:
ID
These represent a unique ID number assigned to each RAID array identified
by the BIOS.
Mode
This identifies the RAID mode configuration that the array is defined as.
- 12 -