User manual

SuperTrak SX6000™ User Manual Chapter 2
- 6 -
Audible Event Alarm
Array Status LEDs
I960RM RISC Processo
r
Hardware XOR Accelerator
Cache Memory Socket
Ultra ATA/100 Controller
Channel 1
1
2
3
4
5
6
Figure 1 SuperTrak SX6000 controller card
Cables
Ultra ATA/100 drive cables are provided with the SuperTrak SX6000 controller card.
These cables must be used with Ultra ATA/100 and Ultra ATA/66 drives in order to
realize full Ultra ATA/100 and/or Ultra ATA/66 specs. They differ from older 40-wire/40-
pin IDE cables by adding an extra ground wire between each data wire, resulting in an
80-wire/40-pin cable.
NOTE: Do not use cables that are longer than 18”. Such cables are out of spec and can
cause data integrity problems.
Quick Installation Checklist
Refer to this checklist to ensure that all hardware and software components necessary
for your SuperTrak SX6000 to operate efficiently are installed.
Hardware Installation
 At least one drive set at Master and is attached to the controller.
 SuperTrak SX6000 controller card is fully inserted into a bus mastering
PCI slot and mounted with a bracket screw.
 Minimum of 16MB RAM is inserted into the DIMM slot on the controller
card.