User manual

63
Chapter 4: Management with SuperBuild™
• SuperTrak BIOS (below)
• Accessing the Main Menu (page 66)
• Viewing Controller Information (page 67)
• Managing Physical Drives (page 68)
• Managing Disk Arrays (page 70)
• Managing Logical Drives (page 73)
• Managing Spare Drives (page 77)
• Using the Miscellaneous Menu (page 80)
SuperTrak BIOS
This section explains the information that you can obtain from the SuperTrak
BIOS.
When the SuperTrak BIOS loads during boot up, the BIOS displays pertinent
information about the RAID logical drives. At this point, press Ctrl-S to enter the
SuperBuild Configuration Utility.
The SuperTrak BIOS screen displays the following information about your logical
drives:
• ID – A number beginning with zero, assigned by the controller.
• Name – The name you assigned when you created the logical drive.
• Capacity – The number of physical drives attached to this controller.
• Status – OK, Critical, or Offline.
See Figure 1.