User manual

SuperTrak TX Series User Manual
30
Installing WebPAM PRO
WebPAM PRO adds three components to your PC or server:
• Utility Server
• Agent
• Command Line Interface (CLI)
Utility Server
The Utility Server can run on the Host PC (where the SuperTrak card is installed),
or on a networked PC, if your WebPAM PRO system includes remote
management over a network. You run the Utility Server by directing your browser
to the IP address of the Host PC.
Agent
The Agent runs on the Host PC (where the SuperTrak card is installed). After you
have logged into the Utility Server through WebPAM PRO, the Utility Server
accesses the Agent on the Host PC. The Agent has its own Java Runtime
Environment (JRE).
Operating System Support
On the Host PC where you install the SuperTrak controller and WebPAM PRO,
Promise Technology recommends:
• Windows Server 2008 SP1 (32 or 64 bit)
• Windows Vista SP1 (32 or 64 bit)
• Windows Server 2003 SP2 (32 or 64 bit)
• Windows XP SP2 (64 bit)
• Windows XP SP3 (32 bit)
• Red Hat Enterprise Linux 5.0, 5.1, 5.2 (32 or 64 bit)
• SuSE Linux Enterprise Server 10 SP2, UP and SMP, (32 or 64 bit)
• SuSE Linux Enterprise Server 10 SP1, UP and SMP, (32 or 64 bit)
• Open SuSE Linux Enterprise Server 10.2, 10.3, 11 (32 or 64 bit)
Choose one of these operating systems to take full advantage of all the features
of WebPAM PRO.