User manual

SuperTrak TX Series User Manual
16
11. Highlight Next Step and press Enter.
The Create Logical Drive Step 2/2 screen appears.
12. Press the arrow keys to highlight Logical Drive Name. Type a name for your
logical drive and press Enter.
13. Optional. You can change any of the following parameters or use the default
settings.
• To change the RAID Level, highlight RAID Level and press Enter.
In the popup menu, highlight your choice of RAID Level and press
Enter.
The available RAID Levels depend on the number of physical drives you
selected for your disk array.
• To use less than the full physical drive capacity for this logical drive,
highlight Capacity and type the new capacity in GB to allocate to this
logical drive.
Later, you can assign the unused capacity to additional logical drives.
• To change the Stripe Size, highlight Stripe Size and press Enter.
Highlight your choice of 64 KB or 128 KB and press Enter.
• To change the Sector Size, highlight Sector Size and press Enter.
Use the default 512 Bytes. Only exceptions are logical drives larger than
2 TB on Windows XP 32-bit. See page 178 for more information.
14. Highlight Save Configuration and press Enter.
The Logical Drive Management screen appears with your new logical drive.
Create Logical Drive (Step 1/2)
Select a Disk Array
ID Capacity Status
*0 459.77 GB Ok
- - -
- - -
- - -
- - -
- - -
- - -
- - -
Next Step
Return to Previous MenuPrevious Menu
Create Logical Drive (Step 2/2)
Disk Array ID : DA1
Capacity (Free) : 470.814 GB
Logical Drive Name : LogDrv A
RAID Level : RAID 10
Capacity : 0 GB ( 0:Auto )
Stripe Size : 64 KB
Sector Size : 512 Bytes
Save Configuration
Return to Previous Menu