User manual

SuperTrak TX Series User Manual
162
stop Stops a Rebuild.
pause Pauses a Rebuild.
resume Resumes a paused Rebuild.
-d <DA ID> Specifies which disk array on which to perform the
Rebuild.
-s <sequence Num> Specifies the sequence number of the failed physical
drive. The source drive of the Rebuild.
-p <PD ID> Specifies the ID of the replacement physical drive. The
target drive of the Rebuild.
Examples
rb
rb -a start -d0 -s2 -p10
rb -a stop -d0 -s2
rc
Usage
rc [-a <action>] [-l <LdId>]
rc -a start -l <LdId> [-n] [-p]
rc -a stop -l <LdId>
rc -a pause -l <LdId>
rc -a resume -l <LdId>
Summary
The rc command starts, stops, pauses and resumes a Redundancy Check and
monitors the progress of a running Redundancy Check.
Options
-a <action> Specifies action to perform.
list (Default) Displays active and paused Redundancy
Checks and their status.
start Starts a Redundancy Check.
stop Stops a Redundancy Check.
pause Pauses a Redundancy Check.
resume Resumes a paused Redundancy Check.
-l <Ld ID> Specifies the logical drive ID on which to run the
Redundancy Check.