User manual

SuperTrak TX Series User Manual
120
Managing Disk Arrays
Disk Array Management includes the following functions:
• Viewing Disk Arrays (page 120)
• Locating a Disk Array (page 120)
• Creating a Disk Array (page 121)
• Deleting a Disk Array (page 127)
• Viewing Disk Array Information (page 127)
• Creating a Logical Drive (page 128)
• Deleting a Logical Drive (page 129)
• Migrating a Disk Array (page 130)
• Rebuilding a Disk Array (page 131)
• Preparing a Disk Array for Transport (page 132)
Viewing Disk Arrays
To view the disk arrays in this enclosure plus any expanded or cascaded
enclosures:
1. Click the Subsystem icon in Tree View.
2. Click the Disk Arrays icon.
A list of disk arrays appears in Management View.
Click the DA link to view a specific disk array. See “Viewing Disk Array
Information” on page 127.
Locating a Disk Array
Virtual or Third Party Enclosures
Support for this feature depends on how your system or enclosure was set up.
Direct-connect systems with individual LED connections and SGPIO enclosures
support individual physical drive LEDs. Other systems or enclosures might or
might not support them. See “Appendix C: LED Backplane Connections” on
page 215.
To locate a disk array in the enclosure, click the Locate DAx button. The LEDs
for the carriers holding the physical drives used by the disk array will blink for one
minute.
Promise Enclosures
To locate a disk array in a VTrak JBOD enclosure, click the Locate DAx button.
The disk status LEDs will blink for one minute to identify the carriers holding the
physical drives used by the disk array.