User manual

SuperTrak EX Series User Manual
194
<Ld count> Specifies the number of logical drives to be created with
the -a add option. With the -c option, all the logical drives
have same settings but only one -l option=value can be
specified.
-t <condition type> Specifies the type of incomplete condition to accept. If not
specified, it will accept the current incomplete condition
by default.
missingdrive The condition of missing drive in the array.
missingwatermark The condition of missing NVRAM watermark of the array.
-v Verbose mode. Displays all array properties, requires -a list option.
Examples
array -v -c 1
array -a add -s "alias=MyArray,mediapatrol=enable" -p 1,3,5~9
-l "raid=5,capacity=50gb,stripe=256kb,sector=1kb"
array -a add -p 1,3,5~9 -l "raid=5,capacity=50gb,stripe=256kb"
-l "raid=0,capacity=100gb"
array -a mod -d 1 -s "alias=YourArray,mediapatrol=disable"
array -a del -d 3
array -a locate -d 0
array -a addld -d 0 -l "raid=1e,capacity=125gb,stripe=64kb"
array -a delld -l 1
battery
Usage
battery [-a <action>] [-b <batId>]
battery -a recondition -b <batId>
Summary
The battery command displays the status of a battery by the percentage of
charge left.
On subsystems, this command also reconditions the battery. Reconditioning fully
discharges then fully recharge the battery. The battery is reconditioned
automatically once per month.
Options
-a <action> Specifies the action to perform.
list (Default) List information for all batteries or a specific
battery.