User manual

SuperTrak EX Series User Manual
150
might not support them. See “Appendix D: LED Backplane Connections” on
page 295.
To locate a physical drive in the enclosure, click the Locate PDx button. The LED
for the carrier holding the physical drive will blink for one minute.
Promise Enclosures
To locate a physical drive in the VTrak JBOD enclosure, click the Locate PDx
button. The disk status LED will blink for one minute to identify the carrier holding
the physical drive.
Figure 6. VTrak drive carrier LEDs
Making Global Physical Drive Settings
Global settings apply to all of the physical disk drives installed under the
SuperTrak controller. The functions include:
To make global physical drive settings:
1. Click the Subsystem icon in Tree View.
2. Click the Enclosures icon.
3. Click the Enclosure icon.
4. Click the Physical Drives icon.
5. Click the Global Settings tab in Management View.
6. Check the features you want to enable.
Uncheck any features you want to disable.
7. Click the Submit button.
The changes take effect immediately.
SATA Drives SAS Drives
• Enable Write Cache
• Enable Read Look Ahead Cache
• Enable Command Queuing
• Enable Write Cache
• Enable Read Look Ahead Cache
• Enable Read Cache
Disk Status
Power/Activity