User manual

Chapter 4: SuperBuild™ Utility
89
• Miscellaneous – SAS drive LEDs, enclosure management, and buzzer
settings
Selecting a Controller
The SuperBuild Configuration utility supports up to two SuperTrak RAID
Controller cards installed in the same Host PC. Controller selection enables you
to select which of the two SuperTrak controllers the utility accesses.
If you have only one SuperTrak card installed in the Host PC, the SuperTrak is
Controller 1, and no selection is necessary.
If you have two SuperTrak cards installed in the Host PC, take the following
action to select one of them:
1. In the Main Menu, highlight Controller Selection and press Enter.
2. Highlight Controller 1 or Controller 2 and press Enter.
The selected controller (SuperTrak card) displays in the SuperBuild utility.
Viewing Controller Information
The SuperBuild utility displays information about the selected SuperTrak EX
controller.
1. In the Main Menu, highlight Controller Information and press Enter.
The information includes:
Vendor – Promise Technology, Inc.
Model – SuperTrak EX4650, 8650, 8654, EX8658, or EX16650
WWN – World Wide Number of the SuperTrak controller
Memory Type – DDR2 SDRAM
Memory Size – 128 MB, 256 MB, or 512 MB
Single Image Ver – The version number of the image used to update the
firmware on the SuperTrak EX controller.*
Firmware Version – The version number of the firmware currently installed
on the SuperTrak EX controller.*
BIOS Version – The version number of the BIOS currently installed on the
SuperTrak EX controller.*
PCI Func Address – The functional address of the SuperTrak card in the
Host PC. Used for advanced diagnostics
* The BIOS and Firmware are upgradable. See “Downloading BIOS and
Firmware File” on page 289 and See “Updating the Firmware” on
page 132.
2. Highlight Return to Previous Menu and press Enter.