Product manual

Appendix B: Maintenance
143
When the installation is done, a system message appears.
8. Click the OK button on the system message.
Rebooting the SmartStor
To reboot the SmartStor after a plug-in installation:
1. In the Tree, click on the + beside the System icon.
2. Click on the Reboot / Shutdown icon.
3. Click on the Reboot option.
4. Click the OK button.
5. In the confirmation box, click the OK button.
The reboot runs automatically. When the SmartStor is
fully booted:
• The System Status LED turns green (right)
• The buzzer beeps one time (if the buzzer is
enabled)
Connection Problems After Restart
If your SmartStor’s network settings were set to Obtain an IP address
automatically, your DHCP server might assign a different IP address to the
SmartStor when you restart the SmartStor after is was shutdown for repairs.
This condition does not apply if you assigned your SmartStor’s IP address
manually.
If you experience network drive or printer connection failures, check the
SmartStor’s current IP address. See “Finding the SmartStor’s IP Address” on
page 21. If the SmartStor’s IP address has changed, your previous network
drives and printer connections will no longer work.
Here are two possible solutions:
• You may be able to reset the SmartStor’s IP address manually. See
“Changing the SmartStor’s Network Settings” on page 53 or “Making
Network Settings” on page 85.
Warning
Do not disconnect the power or shut down the SmartStor while the
installation is running!
System
Status
LED