User's Manual

SmartStor NS4300N Product Manual
120
Checking Enclosure Status in PASM
To check Enclosure status:
1. Start PASM.
See “PASM in your Browser” on page 60.
Or see “PASM in SmartSYNC” on page 61.
2. In the Tree, click the + beside the System icon.
3. Click the System Information icon.
4. Click the Enclosure Information tab.
See Figure 5.
Migration or Rebuilding
on array X paused at Y%.
RAID Volume Migration or Rebuild was paused
temporarily by user action.
Migration or Rebuilding
on array X resumed at
Y%.
RAID Volume Migration or Rebuild was paused and
then resumed by user action.
Migration or Rebuilding
on array X completed.
RAID Volume Migration or Rebuild has finished.
Normal.
Migration or Rebuilding
on array X aborted at Y%
RAID Volume Migration or Rebuild was aborted
(stopped) by user action.
Migration or Rebuilding
on array X aborted at Y%
because of error.
RAID Volume Migration or Rebuild has aborted
(stopped) because of an error. Check the disk drives.
See page 112. Check the RAID Volume. See
page 113.
RAID status: "OFFLINE".
The NS4300N X volume
Y is offline.
Check the disk drives. See page 112. Replace the
failed drive. See page 113. Create a new RAID
Volume. See page 80.
RAID status: "CRITICAL".
The NS4300N X volume
Y is not functioning
correctly.
Check the disk drives. See page 112. Replace the
failed drive. See page 113. The RAID Volume will
rebuild automatically.
RAID X had some errors.
Formatting was aborted!
Check the disk drives. See page 112. Replace the
failed drive. See page 113.
Reported Event Corrective Action