User manual

10
Promise Technologies Pegasus J4User Manual
connecting the power and thUnderbolt cableS
Follow the instructions below to connect the underbolt™ cable and power cord.
To power the Pegasus unit:
1. Attach the power cord including with the J4 to the power receptacle on the rear panel. Plug the other
end into a suitable power source.
2. Connect one end of the underbolt cable to either underbolt port on the back of J4. It should be
oriented so that the underbolt symbol printed on the connector housing faces down, that is , so that
the symbol is on the underside of the connector when it is lined up with the port. Insert the connector
into the port so the edge of the connector housing touches the rear panel facing of the J4.
3. Connect the other end of the underbolt cable to a computer equipped with a underbolt port.
Note that the orientation of the underbolt port on the computer might be dierent than that of the
J4. Make sure the connector is lined up properly before pushing it into the port on the computer.
See “Powerandunderboltconnections”onpage11.
Connect power cable
✓