Installation guide

32
Pegasus J2 Windows Installation Guide
J2 hardWare
e Pegasus J2 drive can be used with or without the power adapter. To use the power adapter, rst
read “Assemble the power adapter” on page 34 to assemble it with the type of plug for the socket used
in your electrical system.
Thunderbolt Port
Use a Thunderbolt cable to connect the J2 to a Thunderbolt ready computer. This connection
completes the physical link to the J2, this is the path through which the SATA link is established.
Make sure the connector is properly oriented to both devices. For the cable connection to the J2,
the connector should be oriented so Thunderbolt logo and the Pegasus logo on the top of the J2
are both facing the same direction. So if the J2 is placed top side up on a desk, the Thunderbolt
logo on the connector will be facing up. When the cable is properly connected, the Performance
LED will light after a few seconds.
Pegasus J2 drive
Performance LED
Thunderbolt Port
Power adapter receptacle
(behind protective cover)