User manual

WebPAM User Manual
16
When the Install Complete screen appears, the installation process is
finished. Click the Finish button to go to the Promise Registration
website.
WebPAM to UltraTrak Connections
In order to use WebPAM to manage your UltraTrak arrays, the RAID PC
must be properly connected to the UltraTrak unit. There are two ways to
do this:
RS232 Serial Port – This method communicates through the Serial
Ports on the RAID PC and UltraTrak (see below). It allows for only one
UltraTrak to be managed per RAID PC. If you choose this method,
connect the Null Modem Cable before you install and configure
WebPAM.
SCSI Bus – This method communicated through the SCSI bus using In-
Band SCSI technology. You can manage multiple UltraTraks with this
connection method. If you choose this method, you must:
• Install the RAID Console driver from the UltraTrak CD
• Run UltraTrak Firmware Build 13 or later
• Enable the SCSI Base Mgt option on UltraTrak
Refer to the UltraTrak User Manual and Appendix C of this manual for
further information.
FAN1
FAN2FAN3
SCSI IOUT/TERM
COM
SCSI IN
Figure 13. RM15000 SCSI and Serial Connections
This completes the WebPAM installation. Go on to Chapter 3, Initial
Setup.
SCSI Cable from Serial (DB-9) Null Modem Cable
Host SCSI Port Connector from Host Serial Port
SCSI Input
Connector