User guide

If a redundancy check is scheduled, the screen display changes to the schedule list screen. The
scheduling just set is added to the list. Message "schedule was created successfully." appears at
the top of the tab.
When the time reaches the start time previously set, the redundancy check starts. The
redundancy check is repeated at the intervals entered in step 3.
IMPORTANT: A Redundancy check without Auto Fix of
a logical drive not full-initialized or not subject to
redundancy check in the Auto Fix mode at all cannot be
scheduled.
If you try, the following message is registered and
redundancy check is not done.
Failed to create the scheduler: Redundancy
Check can not be scheduled for logical drive
x as it is not fully initialized or AutoFix
is not enabled.
In this case, run the redundancy check in Auto Fix once.
Changing the schedule setting
1. Click the subsystem (ST EX4650EL) icon in the Tree View.
2. Click the Scheduler tab in the Management Window and then click the link of the redundancy
check for which you want to change the schedule setting.
The rest of the procedure is identical to the creation of the schedule.
Suspending (deleting) schedule setting
1. Click the subsystem (ST EX4650EL) icon in the Tree View.
2. Click the arrow at the right end of the Scheduler tab in the Management Window and then
click Delete Schedules.
3. Check the checkbox of the redundancy check which you want to delete and click [Submit].
When prompted to confirm, click [OK].
NOTE: You can set a single schedule of redundancy
check for a single logical drive.
- 55 -