User Manual

connect PegAsus2 to your mAc

ToestablishtheThunderboltconnection:

1. ConnectaThunderboltcablefromoneoftheThunderboltportsonthebackofthePegasus2to

theThunderboltportonyourMaccomputer.See“Thunderboltandpowerconnections”onpage

2. If the Pegasus2 is plugged into a power source and the Mac is running, the Pegasus2 will power

onandbegintobootup.See“Power modes on the Pegasus2” on page 13 for information on

powerupandshutdownbehavior.

You will notice the following:

• ThePowerButtonLEDlightsorangeatrst,thenblue.

• ThedrivecarrierPower/StatusLEDslightblue.

• TheThunderboltLinkLEDfortheportconnectedtotheMaclightsblue.

See “Pegasus2 R4 front view” on page 4 for illustration of the front of the device.

• The“PROMISERAID”storagedriveicon(seepicturebelow)appearsonyourdesktop.

This indicates the Pegasus2 is ready for use.

Note

If the Thunderbolt cable is connected to a Mac that is running, the Pegasus2 will

power up as soon as the power is connected. This is a new feature for the Pegasus2.

Note

When the device is powered on by connecting the Thunderbolt cable, or by pressing

the Power Button, the Power Button turns orange. It takes about 30 seconds to start

the Pegasus2 unit.

Promise Technologies