User manual

Appendix D: LED Backplane Connections
215
To set up your system for direct (fault and activity) LEDs, you must know how the
SuperTrak’s firmware status corresponds to LED behavior. That relationship is
shown in the table below.
LED 1
(Fault)
LED 2
(Activity)
Firmware Status
OFF OFF No physical drive
ON ON Unconfigured physical drive
OFF ON Configured physical drive – Status OK
ON ON Configured physical drive – Status Not OK
OFF ON Global spare drive – Status OK
ON ON Physical drive – Status Dead
ON ON Stale condition
Blink ON Rebuilding
OFF Blink Activity
Blink ON Locate physical drive
Blink ON Locate logical drive
Blink ON Locate disk array