User manual

· Remove the enclosures from the UltraTrak100
Unit by opening the key to the open position.
· Insert the drives in each Enclosure so that each
drive is mounted properly,
· on the bottom of the enclosure you will find
four screws that will help secure the drive to the
enclosure.
· Before screwing the drive in place make sure
that the drive is connected properly.
· Insert the drive enclosure in the bay (NOTE:
be careful when inserting your bay into the
UltraTrak unit).
· Securely close the lever and make certain to
engage the keylock to turn your drive on and
set it as active.
AUTOMATIC RAID 5 Congiuration: Boot the UltraTrak100. After booting the
UltraTrak will display a screen “No array is defined”. Press the select key, the screen
will display "Auto Array Setup". Press the Select key. The screen will display
"*RAID Level" Press Select. Scroll down to "*Raid 5", press Select. You will see
the message "Press SEL to create Press Exit to cancel” press SEL “Array has been
created Please Restart UltraTrak.” follow the displayed message. After restarting the
UltraTrak100 you notice that LCD screen displays the following message “Array
Functional” or if you prefer to configure the array manually please read the following
page.
Setting up a Raid 5 configuration: (Manual Configuration)