User manual

Quick install Guide for UltraTrak100 TX4/TX8

1. Take the unit out of the box. In the box you will see the

following components:

I. One SCSI ultra wide SCSI cable

II. Terminator

III. Power Cable

IV. Manual

V. Keys

2. Connecting your UltraTrak configuration.

Connect the SCSI cable and proper termination of the SCSI ports (as required) on the

UltraTrak unit.

Use Ultra2 LVD SCSI or Ultra 3 compatible SCSI controller.

· Make certain if your UltraTrak is the last

Device on your SCSI chain that you use proper

termination.

· If your UltraTrak is the last device make

certain that you terminate the lower SCSI OUT

port.

· Please see picture from proper termination

example.

· Next you will need to connect your SCSI

cable to your UltraTrak unit.

· In this particular example the UltraTrak is

terminated (being the last device in the chain).

· The SCSI cable is plugged into the upper

SCSI IN port.

· Make certain to select the correct voltage

setting for your area and then plug in your

power chord.

3. Installing the drives in the Enclosures & UltraTrak

PAGE 1
Quick install Guide for UltraTrak100 TX4/TX8 1. Take the unit out of the box. In the box you will see the following components: I. II. III. IV. V. One SCSI ultra wide SCSI cable Terminator Power Cable Manual Keys 2. Connecting your UltraTrak configuration. Connect the SCSI cable and proper termination of the SCSI ports (as required) on the UltraTrak unit. Use Ultra2 LVD SCSI or Ultra 3 compatible SCSI controller.
PAGE 2
· Remove the enclosures from the UltraTrak100 Unit by opening the key to the open position. · Insert the drives in each Enclosure so that each drive is mounted properly, · on the bottom of the enclosure you will find four screws that will help secure the drive to the enclosure. · Before screwing the drive in place make sure that the drive is connected properly. · Insert the drive enclosure in the bay (NOTE: be careful when inserting your bay into the UltraTrak unit).
PAGE 3
I. Hard Drive Requirements a. minimum of 3 drives required for a Raid 5 configuration. b. All drives connected must be set to a Master or Single jumper position.. c. The UltraTrak100 TX4 uses up to four IDE drives. d. The UltraTrak 100TX8 uses up to eight IDE drives. II. Configuring a Raid 5 with your UltraTrak LCD screen a. Power on the UltraTrak100 . b. When the UltraTrak100 has completed booting, you will see a screen that says “No array is defined”. c. Press the select key. d.