User manual

Chapter 1: Introduction to SmartStor

• SmartSYNC Backup Utility

• Setup Wizard Utility

Specifications

• Disk drive support:

• Four 1.5 Gb/s or 3 Gb/s SATA 3.5-inch disk drives

• Conforms to Serial ATA 1.0 specification and Serial ATA II: Extensions

to Serial ATA 1.0 specification (SATA II, phase I specification)

• SATA specification of 3 Gb/s transfers with CRC error-checking

• Hot-swapping of disk drives

• Tagged command queuing

• Native command queuing

• Drive roaming among channels

• S.M.A.R.T. status polled every 15 minutes

• Online capacity expansion

• RAID Level Migration

• Hot spare drives

• RAID Volume rebuilding

• Gigabyte rounding

• Background rebuilding

• RAID level support: RAID 0, 1, 5, and 10

• Large file system support up to 4 TB

• Unicode file name support

• SATA RAID Controller: Promise PDC40719

• Server on a Chip: Freescale MPC8343, 400MHz

• Networking: 10/100/1000 Mb/s Ethernet Port on motherboard

• USB ports: USB 2.0, up to 480 Mb/s, two Type-A connectors

• File protocols: SMB, CIFS, FTP, AFP, NFS

• Flash Memory: 16 MB, 16-bit

• Memory: 128 MB DDR SDRAM

• Power Supply: 200-watt ATX with PFC

• Network Time Protocol (NTP) client

• Error logging

• Phone home capability (email notification) to contact IT staff