Product manual

VTrak J830s, J630s Product Manual
42
The route command displays SAS addresses that are attached to the SAS ports
of the VTrak unit. Three items are reported:
• Index – Arbitrary numbers, listed in numerical sequence.
• SAS Address – SAS address of the drive or component.
• CN# – Downstream SAS port connector number. See page 21 for a diagram
of connectors on the I/O module.
• Phy number – Links are individual Phys, numbered 0 through 31 on J830s
units, and 0 through 23 on J630s units.
Route Troubleshooting
At the cli> prompt, if you type route and press Enter, and your system returns:
No SAS Routing Entry Exists
It indicates that no downstream devices are found.
Uptime Command
The uptime command informs you of the elapsed period of time since the VTrak
unit was powered on.
To display uptime:
At the cli> prompt, type uptime and press Enter.
cli>uptime
The system returns:
System has been running for : 1 day 9 hours 46 minutes 36 seconds
I/O Module1 has been running for: 1 day 9 hours 46 minutes 36 seconds
I/O Module2 has been running for: 1 day 9 hours 46 minutes 32 seconds
Note that I/O module 1, the default primary module, started before I/O module 2.
See page 32 for more information.
? Command
The VTrak CLI uses the standard Unix online help system.
For the command usage:
At the cli> prompt, type the command, followed by -? and press Enter.
cli>enclosure -?
cli>link -?
cli>route -?
Choose any command from the list under “Command Line Interface” on page 32.