Product manual

VTrak J830s, J630s Product Manual
32
Command Line Interface
• Command Set (page 32)
• Enclosure Command (page 32)
• Making Enclosure Settings (page 35)
• Factorydefaults Command (page 37)
• Help Command (page 37)
• Link Command (page 38)
• Route Command (page 41)
• Uptime Command (page 42)
• ? Command (page 42)
Command Set
The CLI uses the following set of commands:
enclosure – Displays enclosure settings and component information.
factorydefaults – Restores the factory default settings to the enclosure.
help – Use alone to see the list of commands. Use with a command to see a list
of options. Examples: enclosure -help and help enclosure.
link – Displays the current status of the Phys (links) and the error counter.
route – Displays table routing information (downstream connections).
uptime – Displays the number of days, hours, minutes and seconds since the
firmware was loaded (since the VTrak was started or restarted).
? – Use alone to see the list of commands. Use with a command to see a list of
options. Example: enclosure -?
Commands and options are not case-sensitive.
Enclosure Command
The Enclosure command performs the following functions:
• Viewing Enclosure Information (page 33)
• Making Enclosure Settings (page 35)
The CLI reports information for the I/O module to which it is connected and for the
rest of the components in the VTrak enclosure.
The VTrak units ship with one or two I/O modules. I/O module 1, on the left, is the
Default Primary. See page 23.
Under SAS specifications, both I/O modules are active at the same time. The
terms Primary and Secondary are for enclosure management purposes only.