Product manual

Chapter 3: Management

• Front Panel LEDs (below)

• Drive Carrier LEDs (page 28)

• Power Supply LED (page 29)

• I/O Module LEDs (page 30)

• Shutting Down and Restarting the VTrak (page 31)

• Command Line Interface (page 32)

Front Panel LEDs

The LEDs on the front panel of the VTrak J830s or J630s unit provide important

status information about the subsystem.

When boot-up is finished and the VTrak subsystem is functioning normally:

• Power and Global enclosure status LEDs display green continuously.

• I/O module activity LEDs flash green when there is activity on the SAS ports.

• System heartbeat LED blinks green once every 4 seconds if one I/O module

is installed or once every 2 seconds if two I/O modules are installed.

Figure 1. VTrak J630s front panel LED display. The J830s is similar

See the table on the next page for more information.

Power

I/O module-2 activity

Global enclosure status

Reserved

I/O module-1 activity

Heartbeat