Product manual

VTrak J830s, J630s Product Manual
24
Connecting the Power
VTrak ships with clip assemblies to secure the power cords.
To secure the power cords:
1. Insert the barbed end of the band into the hole until it snaps into place.
2. Attach the power cord to the power supply.
3. Place the clip over the power cord, slide the clip to the end as shown in the
Figure below, then squeeze the clip to tighten it.
Figure 15.Securing a power cord with the clip assembly
To reposition or release the clip, pull the tabs as shown.
4. Switch on the power supplies.
When the power is switched on, the LEDs light up.
Insert the barb
into the hole
Pull this tab to position the clip
Pull this tab to release the clip
Slide the clip to
the end of the
power cord
Power supply
switch