User's Manual

Chapter 2: Installation

Figure 21.VTrak J610s/J310s disk carrier LEDs

Within one minute, the Power/Activity should display Green.

If there is no disk drive in the carrier, the Disk Status LED and the Power/Activity

LED will remain dark.

Setting Up the CLI Connection

The J610s or J310s unit has a Command Line Interface (CLI) to manage all of its

functions, including customization. Access the CLI via your PC’s terminal VT100

or ANSI emulation program, such as Microsoft HyperTerminal.

With the J610s or J310s unit running and the RJ11-to-DB9 serial data cable with

a null-modem cable connected to the primary I/O module:

1. Change your terminal emulation program settings to agree with the

following:

• Bits per second: 115200

• Data bits: 8

• Parity: None

• Stop bits: 1

• Flow control: none

2. Start your PC’s terminal emulation program.

3. Press Enter once to launch the CLI.

The cli> prompt on your screen indicates that you have a connection and the

CLI is ready to accept commands.

See “CLI Command Set” on page 33.

Disk Status

Power/Activity