User's Manual

Chapter 3: Management
39
P15 ---------- ---------- ---------- ---------- ---------- ---------- 0x01
P16 ---------- ---------- ---------- ---------- ---------- ---------- ----------
P17 ---------- ---------- ---------- ---------- ---------- ---------- ----------
P18 ---------- ---------- ---------- ---------- ---------- ---------- ----------
P19 ---------- ---------- ---------- ---------- ---------- ---------- ----------
InDW:Invalid Dword Count DsEr:Disparity Err Count
DwLo:Dword Sync Loss Count
PhRe:Phy Reset Problem Count CoVi:Code Violations Cnt
PRBS:PRBS Error Count
PhCh:Phy Change Count
The following items are reported in the table above. All counts are hexadecimal:
• Link number – Links are Phys, numbered P0 through P23
• Invalid D-word Count
• Disparity Error Count
• Phy Reset Problem Count
• Code Violation Count
• Pseudo-Random Bit-Stream Error Count
• Phy Change Count
If the count is zero, the counter shows dashes (----------). The fact that errors
occur does not necessarily indicate a problem or that the J610s or J310s unit is
malfunctioning.
An individual error count incrementing at intervals of less than six minutes
indicates a possible problem and requires further investigation.
To clear the link error count, at the cli> prompt, type link -a clear and press
Enter.
Route Command
Use this command to show the SAS addresses of the devices in your domain.
At the cli> prompt, type route and press Enter.
Routing Table Mapping:
Entry# SAS Address PortID CnID NextEntry NextValid
-------------------------------------------------------------------------------------
0083 500000E01122C533 0x10 CN1 ---- 0
0121 500000E01122C4A3 0x10 CN1 ---- 0
0226 500000E01122C513 0x10 CN1 ---- 0
0244 500000E011246263 0x10 CN1 ---- 0
0358 500000E011231F43 0x10 CN1 ---- 0
0466 500000E0112770B3 0x10 CN1 ---- 0