User Manual

SuperTrak66™ User's Manual Chapter 2
- 5 -
Getting Started
This chapter is designed to help you prepare SuperTrak66 for installation into
Windows NT 4.0 system servers. Please read through this chapter carefully before
attempting to install SuperTrak66. Users should record their current CMOS
(system setup) settings before making any changes. This preventative measure is
aimed at protecting such information from loss, which may happen unpredictably
and/or periodically during any hardware installation.
2.1 Unpacking SuperTrak66
The SuperTrak66 package should contain the following items:
• SuperTrak66 controller card
• SuperTrak66 User’s Manual
• SuperTrak66 OS drivers & utility diskettes (3)
• Internal 18” Ultra ATA/66 80-wire/40-pin hard drive cables (4)
NOTE: Unit may ship with 16MB 72-pin EDO SIMM
If any of the items are missing or appear damaged, please contact your dealer or
distributor immediately.
NOTE: The SuperTrak66 controller card ships with two removable protective labels
that cover the audible alarm buzzer device (see Figure 1) and the battery (see
Figure 1) which maintains the non-volatile RAM memory. These labels must be
removed prior to installing the card.