User Manual

SuperTrak66™ User's Manual Chapter 5
- 92 -
Using Rebuild Wizard
Step 1
1) Select the correct Target drive which will receive data (see below) Make sure
you select the blank new or replacement drive. The unselected drive(s) will
contain “good” data. This will be the remaining working drive(s) of an array, or
a system drive containing existing data that you wish to mirror.
NOTE: Make absolutely sure and double-check which drive is which. If data exists
on the target drive, it will be over-written.
2) Click the Next button to proceed to Step 2 or Cancel button to stop.
Figure 72: Rebuild Wizard Step 1