Service manual

Panorama® Service Manual 0070-10-0634 7 - 5
Appendix A Panorama Motherboard CMOS Setup/Verification
POWER MANAGEMENT SETUP
POWER MANAGEMENT: DISABLED
PM CONTROL BY APM: NO
VIDEO OFF METHOD: V/H SYNC+BLANK
VIDEO OFF AFTER: STANDBY
MODEM USE IRQ: NA
DOZE MODE; DISABLED
STANDBY MODE: DISABLED
SUSPEND MODE: DISABLED
HDD POWER DOWN: DISABLED
THROTTLE DUTY CYCLE: 62.5%
ZZ ACTIVE IN SUSPEND: DISABLED
VGA ACTIVE MONITOR: ENABLED
SOFT-OFF BY PWR-BTTN: INSTANT-OFF
CPU FAN OFF IN SUSPEND: ENABLED
IRQ 8 BREAK SUSPEND: DISABLED
** RELOAD GLOBAL TIMER EVENTS **
IRQ(3-7, 9-15), NMI: ENABLED
PRIMARY IDE 0: DISABLED
PRIMARY IDE 1: DISABLED
SECONDARY IDE 0: DISABLED
SECONDARY IDE 1: DISABLED
FLOPPY DISK: DISABLED
SERIAL PORT: ENABLED
PARALLEL PORT: DISABLED
PNP/PCI CONFIGURATION
PNP OS INSTALLED: NO
RESOURCES CONTROLLED BY: MANUAL
RESET CONFIGURATION DATA: DISABLED
IRQ-3 ASSIGNED TO: PCI/ISA PnP
IRQ-4 ASSIGNED TO: PCI/ISA PnP
IRQ-5 ASSIGNED TO: PCI/ISA PnP
IRQ-7 ASSIGNED TO: PCI/ISA PnP
IRQ-9 ASSIGNED TO: PCI/ISA PnP
IRQ-11 ASSIGNED TO: PCI/ISA PnP