Service manual

Panorama Motherboard CMOS Setup/Verification Appendix A
7 - 2 0070-10-0634 Panorama® Service Manual
7.1 Panorama Motherboard CMOS Setup/Verification
Verify that the VGA and Serial cables are connected between the display(s) and the Central
Station. Connect the keyboard and mouse to the Central Station.
NOTE: Do not turn on the system without first connecting the Serial
I/O cable (P/N 0012-00-1257) to the Central Station.
Place each of the monitor power switches to the ON position. Press and release the Central
Station's front panel power switch. Verify that the two LEDs on the front panel are illuminated
during the boot-up process. The power LED (green) should be lit continuously. The HD LED
(red) will only be lit continuously during the boot-up process and then it will only be lit during
hard disk reads.
While the Central Station is performing the memory test, press the DELETE key on the
keyboard to enter the CMOS Setup menu. Follow the on-screen instructions to move through
the menus and setup or verify the CMOS exactly as it appears below. When completed,
select SAVE to CMOS and EXIT to enter these settings into memory.
7.1.1 Tower Cases, 2U Telemetry Server and 4U Central Station
STANDARD CMOS SETUP
Date: Current Date
Time: Current Time
HARD DISKS TYPE SIZE CYLS HEAD PRECOMP SECTOR MODE
Primary Master: AUTO 0 0 0 0 0 LBA
Primary Slave: AUTO 0 0 0 0 0 LBA
Secondary Master: AUTO 0 0 0 0 0 LBA
Secondary Slave: AUTO 0 0 0 0 0 LBA
Drive A: 1.44, 3.5 in.
Drive B: None
Video: EGA/VGA
Halt On: All, but
keyboard
Base Memory: 640K
* Extended Memory: 523264K
Other Memory: 384K
Total Memory: 524288K