Service manual

Panorama® Service Manual 0070-10-0634 6 - 5
Connections and Configuration Introduction
Wireless Telemetry Configuration
ELAN IP Address
Assign the Server an appropriate ELAN IP Address (7.6.6.XXX). Verify that no other device
(Central Station, beside monitors, Telemetry Server) being assigned to the network has the
same ELAN IP Address.
WELAN IP Address
Assign the Server an appropriate WELAN IP Address (7.8.8.XXX). Verify that no other device
(Server, Access Point) being assigned to the network has the same WELAN IP Address. Enter
the WELAN IP Address into the Equipment Configuration List.
Device ID
Note the Device ID number. This will be assigned to the equipment list of the Panorama
Central Station.
608 MHz WMTS Enable
Check the option to enable the WMTS Telemetry. Leave the checkbox blank if you are using
ISM (2.4 GHz) telemetry.
608 MHz WMTS Configuration
1. Select the TIM ID number.
2. Select the Band to be used.
3. Deselect any unusable frequency.
4. Select the RF downlink to be used.
Saving the Configuration
After setting the IP addresses, press the Save and Exit button. After a few seconds, a
confirmation window appears. Press the YES button to save the settings. The system should
reboot at this point. If not,
1. Press the Start button in the lower left corner of the screen.
2. Select Shutdown.
3. Select the Shutdown the Computer option.
4. Press the Yes button to shut down the Server.
6.1.5 Bedside Monitor Communication Configuration
In order to communicate to the Panorama Central Station, a bedside monitor must be
configured for Ethernet protocol and have an IP Address and Subnet Mask address assigned
to it.
Follow the instructions for configuring a bedside monitor for wired or wireless networks.