Service manual

Panorama® Service Manual 0070-10-0634 2 - 29
Repair Information Assembly Instructions
g. Select the newly-created partition.
h. On the Tools menu, click Format.
i. In the Format dialog box, select NTFS file system, and then specify the following:
j. Click Start to initiate the format request. A message warns you that all data on the
disk will be erased. Click OK.
k. Click OK when the Format Complete message appears. Close the format window.
The format process takes approximately 40 minutes.
l. Verify Disk 1 is properly formatted:
FIGURE 2-18 Disk Administrator Window
m. Close the Disk Administrator window.
n. Double-click the My Computer icon. Verify that Drive D: (DBData) is shared. If the
drive is not shared, right click on the drive icon. Click on Sharing (the window
below appears). Select Shared As. Verify that the Shared name is D. Verify user
limit is set to Maximum Allowed. Click on Apply to save your changes. Click on
OK to exit.
• To name the partition, type ‘‘DBData’’ for the Volume Label.
• To scan for bad sectors in the partition during formatting, do a Full Format.
• Do not check the Quick Format or Enable Compression boxes in the Format
Options window.
Disk Administrator
Partition
Tools
View Options Help
Disk 0
19618 MB
Disk 1
152633 MB
C:
ECSB
FAT
259 M
F:
NTSY
NTFS
510 M
E:
Applic
NTFS
2047
G:
Storag
NTFS
3334
Free S
13465
D:
DBData
NTFS
152633 MB