Service manual

Assembly Instructions Repair Information
2 - 28 0070-10-0634 Panorama® Service Manual
5. Press any key to reboot the system.
Formatting the Disclosure Drive
1. Enter the Maintenance Mode on the Panorama Central Station by holding down the
Shift key after the Microsoft Windows NT Version banner is displayed on the blue
screen (see below).
FIGURE 2-17 Windows Version Banner
Continue holding the Shift key until the Logon Information window is displayed.
2. Log on with the following User name and Password:
3. Click OK.
4. Click OK on the Registry Editor window.
The Windows Desktop should now display on the monitor.
Partition and Format Disk 1 (Disclosure Hard Drive)
Run the Administrator Tool Disk Administrator.
1. Press Start in the lower left corner of the display.
2. Select Programs.
3. Select Administrative Tools.
4. Select Disk Administrator. A Disk Administrator information window appears on the
screen.
5. Press OK to update the System Configuration. A Confirmation information window
appears.
6. Select Yes to write a signature on Disk 1.
a. Click on the free space area of Disk 1.
b. Go to the Partition menu, click Create.
c. Verify that the value for Create partition of size equals the full size of Disk 1
(152633 MB), then click OK.
d. Click Yes when a message appears prompting you to confirm the creation of
another primary partition because the partition could not be recognized by MS-
DOS.
e. On the Partition menu, click Commit Changes Now, and then click Yes to
save the changes.
f. Click OK when Disk Administrator informs you that the disks were updated
successfully and advises you to create a new Emergency Repair Disk.
Microsoft ? Windows NT Version 4.0 Build 1381: Service Pack (6)®
1 System Processor [512 MB Memory]
LOGON INFORMATION
User name: swadmin
Password: dscpswadmin