Service manual

Assembly Instructions Repair Information

2 - 26 0070-10-0634 Panorama® Service Manual

2.7.6 Closing the Unit

Tower Cases (Pentium II Motherboards)

1. Depending on the case style install the top and side covers and secure it with four (4) or

six (6) screws.

2. Install the EMI shield onto the front cover and snap the front cover onto the chassis.

2.7.7 Rebooting and Testing the System

1. Reconnect the cables to the Central Station, except for the Patient Network and Central

Network (CAT 5) cables. See the section, “Connections and Configuration”, in this

manual.

NOTE: Do not turn on the system without the Quad I/O serial cable

(P/N 0012-00-1257) connected to the Central Station (only

applies to Tower Cases).

2. Install the keyboard and mouse. Turn the monitor and tower on.

3. If the system hard drive has been replaced, the operating software must be reloaded.

Use the instructions included with the system software CDs to load the software and

configure the system. If the instructions are not available, contact your local Service

Representative or Technical Support Department.

NOTE: There are separate versions of software for the Central

Station and Panorama Wireless Telemetry Server.

4. If one or both of the full disclosure drives have been replaced, the system performs a

selftest and eventually stops at the FastTrak66™ Bios Version Screen (shown below).

NOTE: Step 4 only applies to Tower Cases (software revision 7.XX

and below).

NOTE: If a drive has not been replaced, skip to step 6.

FIGURE 2-13 FastTrac66 Bios Version Screen

FastTrac66 ? Bios Version 1.30 (Build 2)

No Array is defined

厖厖厖厖厖

Press <Ctrl-F> to enter FastBuild ? Utility or

Press <ESC> to continue booting