Manualshelf

Service manual

ManualsBrandsPromise Technology ManualsComputer equipmentFastTRAK66
51525354555657585960
Panorama® Service Manual 0070-10-0634 2 - 25
Repair Information Assembly Instructions
2.7.3.2 CD-ROM Drive and System Hard Drive
Tower Cases
1. Install the replacement drive into the chassis.
2. Connect the power and ribbon cables to the rear of the drive.
3. Secure the drive to the chassis with the four (4) screws (two on either side).
2U Central and 2U Server
1. Install the drive into the hard drive bracket and secure with two screws.
2. Install the bracket back into the chassis.
3. Secure the hard drive bracket to the chassis with the two screws.
4. Connect the ribbon and DC power cables to the hard drive.
4U Central Station (System Hard Drive)
1. Install the System hard drive into the hard drive bracket and secure with the four screws.
2. Install the hard drive bracket into the chassis and secure with two screws.
3. Connect the ribbon and DC power cables to the hard drive.
4U Central Station (CD-ROM and Floppy Drive)
1. Install the CDROM and Floppy drive into the drive bracket and secure each with the four
screws.
2. Install the hard drive bracket into the chassis and secure with four screws.
3. Connect the ribbon and DC power cables to the CD-ROM and Floppy drive.
4U Central Station (Full Disclosure Drives)
1. Install each Disclosure drive into the hard drive bracket and secure with the four screws.
2. Install the hard drive bracket into the chassis and secure with four screws.
3. Connect the ribbon and DC power cables to the hard drive.
2.7.4 Auxiliary Fan
Tower Cases (Pentium II Motherboards)
1. Connect the DC power connector to the fan.
2. Verify that the label on the fan is facing the rear of the chassis, which indicates the
airflow is blowing out.
3. Secure the fan to the rear chassis with the four (4) screws.
2.7.5 CMOS Battery Replacement (BT1)
Locate and remove the existing battery from the motherboard and replace it with a new CR
2032 battery (3V). The positive terminal (+) should be visible. After battery replacement,
verify/set up the CMOS per the Panorama Motherboard CMOS Setup/Verification
information on page 7-2.