Service manual

Assembly Instructions Repair Information
2 - 24 0070-10-0634 Panorama® Service Manual
2.7.2.3 Power Supply
Tower Cases
1. Secure the power supply to the rear of the chassis with four (4) screws.
2. Connect the power connector from the power supply to J29 on the motherboard.
3. Plug a power connector onto each hard drive and into the floppy drive.
2U Central and 2U Server
1. Connect the ATX power connector to the motherboard.
2. Connect the DC power connectors to all the hard drives, CDROM and floppy drives.
3. Secure the supply to the inside of the chassis with the two screws.
4. Secure the supply to the rear panel with three screws. Use tie-wraps as necessary to
dress the cables.
4U Central Station
1. Connect the ATX power connector to the motherboard.
2. Connect the DC power connectors to all the hard drives, CDROM and floppy drives.
3. Secure the supply to the rear panel with the four (4) screws.
4. Use tie-wraps as necessary to dress the cables.
2.7.3 Drive Replacement
2.7.3.1 Floppy Drive and Disclosure Hard Drive(s)
Tower Cases (Pentium II Motherboards)
1. Install the replacement drive into the drive rack.
2. Connect the power and ribbon cables to the rear of the drive.
3. Slide the drive rack into the front of the chassis. Secure the drive rack with three (3)
screws.
4. Connect the power connectors and ribbon cables to the drives.
5. Install a cable retainer bracket to each of the drives.
6. Tighten the screws that secure the cable retainer brackets.
NOTE: After replacement of one or both of the full disclosure hard
drives, the Array must be created and formatted. Follow the
instructions in section 2.7.7.