Service manual

Assembly Instructions Repair Information
2 - 22 0070-10-0634 Panorama® Service Manual
9. Connect the RESET SWITCH wires (white and black wires) to J43 - Polarity does not
matter.
10. Connect the POWER SWITCH wires (black and brown wires) to J54 - Black to pin 8 and
brown to pin 9.
Verify the four (4) dip switches of SW1 are set as follows: 1- ON, 2-OFF, 3- OFF, 4- ON.
2U Central Station
1. Secure the motherboard to the chassis using 10 screws.
2. Connect the ATX power supply connector to J10 on the motherboard.
3. Connect the ATX 12 V power connector to J12 on the motherboard.
4. Connect the 40-pin ribbon cable from the CDROM drive to the IDE2 connector.
5. Connect the 40-pin ribbon cable from the hard drives to the IDE1 connector.
6. Connect the 34-pin ribbon cable from the Floppy drive to the FDD1 connector.
7. Connect the ribbon cable from P0 serial port to J15 on the motherboard.
8. Connect the ribbon cable from P1 serial port to J16 on the motherboard.
9. Connect the ribbon cable from the unmarked serial port to J11 on the motherboard.
10. Connect the speaker connector to pins 1-4 (red to pin 1) on J20.
11. Connect the green LED connector to pins 11-13 (green to pin 11) on J20.
12. Connect the power switch connector to pins 7 and 17 (blue to pin 7) on J20.
13. Connect the reset switch connector to pins 9 and 19 (red to pin 9) on J20.
14. Connect the red LED connector to pins 10 and 20 (black to pin 10) on J20.
2.7.2.2 PC Boards
Tower Cases (Pentium II Motherboards)
1. Plug each PC board into its assigned PCI or AGP slot on the motherboard:
• AGP Display Board into J19
• Serial Controller Board into J17
• Network Interface Board into J16
• RAID Controller Board into J15
• TIM PCI Board into J14
2U and 4U Chassis
• Reinstall the riser card.
• Secure the riser card to the chassis with the appropriate screws.
• Plug the individual PC cards into the riser board.
• Refer to Figure 2-12 for proper location of each board.
• Secure each PC card to the chassis with one screw.