Service manual

Panorama® Service Manual 0070-10-0634 2 - 21
Repair Information Assembly Instructions
2.7 Assembly Instructions
This section provides information to assist the technician in re-assembling components of the
Panorama Wireless Transceiver. If necessary, see Figures 2-8 and 2-9 for reference.
2.7.1 Panorama Wireless Transceiver (WMTS Only)
2.7.1.1 Fan
1. Connect the two (2) black wires to the tabs on the fan.
2. Secure the fan to the chassis with the four (4) screws.
2.7.1.2 Power Supply
1. Secure the power supply to the chassis with the four (4) screws.
2. Connect the AC power input cable.
3. Connect the 5/12 VDC power connector.
4. Connect the 9 VDC power connector.
2.7.1.3 Panorama Wireless Transceiver Board
1. Secure the board to the chassis with the 11 screws.
2. Connect the LED Connector to the board.
3. Connect the Main and Diversity RF connectors to the board.
4. Connect the red and black wires to the 9 VDC power connector.
5. Connect the 5/12 VDC connector to the board.
2.7.2 Central Station and Telemetry Servers
2.7.2.1 Motherboard
Tower Cases, 4U Central Stations and 2U Telemetry Servers
1. Mount the motherboard to the motherboard mounting plate using ten (10) screws.
2. Install the mounting plate into the chassis and secure with four (4) screws.
3. Connect the power connector from the power supply to J29.
4. If necessary, install the microprocessor into U10 and connect the fan into J24 and the
four 128 MB SDRAM chips into U16, U17, U18 and U70.
5. Plug in the PC boards into the PCI and AGP slots on the motherboard.
6. Connect the SPEAKER wires (Red/Black twisted pair) to J54- Black to pin 23 and red to
pin 26.
7. Connect the POWER LED wire (black and green wires) to J54- Black to pin 17 and
green to pin 19.
8. Connect the HARD DRIVE LED wires (black and red wires) to J54 - Black to pin 14 and
red to pin 15.