Manualshelf

Service manual

ManualsBrandsPromise Technology ManualsComputer equipmentFastTRAK66
41424344454647484950
Disassembly Instructions Repair Information
2 - 18 0070-10-0634 Panorama® Service Manual
2.6.8 Floppy Drive and Disclosure Hard Drive(s) Removal
Tower Case
1. Remove the three (3) screws securing the 3.5-inch drive rack to the front of the chassis.
2. Loosen the screws securing the cable retainer bracket to the hard drive. Remove the
cable retainer bracket.
3. Loosen the screws securing the cable retainer bracket to the floppy drive. Remove the
cable retainer bracket.
4. Disconnect the power connectors and ribbon cables from the drive(s).
5. Press up on the locking tab and pull the drive rack out through the front of the chassis.
2U Central Station and 2U Telemetry Server
1. Remove the ribbon and DC power cables from the drive(s).
2. Remove the five (5) screws from the CDROM/Floppy Drive bracket.
3. Remove the two (2) screws from the Full Disclosure drive bracket. Slide the bracket
towards the rear of the chassis. Remove the bracket from the chassis.
4. Remove the screws securing the drive to the bracket. Remove the drive.
4U Central Station
1. Remove the ribbon and DC power cables from the drive(s).
2. Remove the four (4) screws from the CDROM/Floppy Drive and Full Disclosure drive
brackets. Remove the bracket from the chassis.
3. Remove the screws securing the drive to the bracket. Remove the drive.
2.6.9 CD-ROM Drive Removal
Tower Case
1. Remove the four (4) screws (two on either side) securing the drive to the drive rack.
2. Pull the drive out of the drive rack.
2U Central Station and 2U Telemetry Server
1. Remove the ribbon and DC power cables from the drive(s).
2. Remove the four (4) screws from the CDROM/Floppy Drive and Full Disclosure drive
brackets. Remove the bracket from the chassis.
3. Remove the screws securing the drive to the bracket. Remove the drive.
4U Central Station
1. Remove the ribbon and DC power cables from the drive(s).
2. Remove the four (4) screws from the CDROM/Floppy Drive brackets. Remove the
bracket from the chassis.
3. Remove the screws securing the drive to the bracket. Remove the drive.