Service manual

Panorama® Service Manual 0070-10-0634 2 - 15
Repair Information Disassembly Instructions
2.6.1 Top Cover Removal
Tower Case
1. Depending on the case style, remove the four (4) or six (6) screws on the rear of the
Central Station chassis.
2. Slide the cover toward the rear and lift off.
4U Case
1. Remove the thumb screw from the rear of the case.
2. Lift off the top cover.
3. Remove the eight (8) screws securing the cover plate.
4. Remove the cover plate.
2U Case
1. Remove the four (4) screws securing the top cover (2 on each side).
2. Lift off the top cover.
2.6.2 Front Panel Removal (Tower Case Only)
Grab the panel in the opening at the bottom and lift up and away from the chassis.
2.6.3 Power Supply Removal
Tower Case
1. Disconnect the power connector to the motherboard (J29).
2. Disconnect the power connectors from the floppy drive, auxiliary fan, system hard drive,
and disclosure hard drives.
3. Remove the four (4) or six (6) screws securing the power supply to the rear of
the chassis.
2U Case
1. Disconnect the ATX power connector from the motherboard.
2. Disconnect the DC power connectors from all the hard drives, CD-ROM and floppy
drives.
3. Remove the three (3) screws securing the supply to the rear panel.
4. Remove the two screws securing the supply to the inside of the chassis.
5. Remove the power supply. Cut tie-wraps as necessary.
4U Central Station
1. Disconnect the ATX power connector from the motherboard.
2. Disconnect the DC power connectors from all the hard drives, CD-ROM and Floppy
drives.
3. Remove the four (4) screws securing the supply to the rear panel.
4. Remove the power supply. Cut tie-wraps as necessary.