Service manual

Troubleshooting Repair Information

2 - 8 0070-10-0634 Panorama® Service Manual

2.4.3 Communication Loss From All Bedside Monitors

Wired Network

1. Verify AC power to the switch(es). Verify the Power and Status LEDs on the switch(es). Re-

boot the switch(es).

2. Verify the Status LED for the port connecting the Central Station to the switch.

• If not illuminated, connect the patch cable to another port on the switch. If the Status

LED still does not illuminate, the problem may be with the network card in the Central

Station.

3. Verify the LEDs on the Patient Network card on the Central Station.

• If not illuminated, the network card may be defective.

Wireless Network (2.4 GHz)

1. Verify AC power to the switch. Check the Power and Status LEDs on the switch. Re-boot

the switch.

Connect a display to the Panorama Wireless Telemetry Server. Verify AC power to the

Panorama Wireless Telemetry Server.

Reboot the Server, verify if the power and hard drive LEDs are illuminated and the fans

are operating.

After the reboot, the CB configuration screen should display the following:

FIGURE 2-4 CB Configuration Screen

This indicates that the Panorama Wireless Telemetry Server is communicating to an Access

Point. If nothing is displayed in the window, the Panorama Wireless Telemetry Server is not

communicating to any Access Points.

If the display still does not come on, there is a problem within the Server.

Translator Found and is still communicating