Service manual

Troubleshooting Repair Information

2 - 6 0070-10-0634 Panorama® Service Manual

FIGURE 2-1 Bedside Monitor (Wired Network)

Wireless Network (2.4 GHz)

1. Verify that the Radio Icon is displayed on the bedside monitor. The Radio Icon indicates

the Radio Card is being detected by the monitor. See Figure 2-2.

FIGURE 2-2 Bedside Monitor (Wireless)

• If the Radio Icon is not displayed, verify that the bedside monitor is properly

configured for the wireless network.

• If the bedside monitor is configured properly, replace the radio card.

• Verify the LED on the Radio card in the bedside monitor is rapidly flashing. This

indicates the Radio card is transmitting with the Access Point. If the LED is slowly

pulsing in an on/off manner, the Radio card is not communicating with the Access

Point.